[Snowgirl90]

I got the CRF 250m which is pretty much same bike as the L. Anyways I added a new led tail light and led rear turn signals and they did light up but tail light was 100% on so it dosent change if i brake. And when i wanna turn the back turnsignals hyper blinks deppending on which way I going. When I added next the new front turn signals they wouldnt light up at all while back would stay light but only just a little so u could barly see they where on. What should i do to fix this issue?

[Hazen9]

Start by adding a resistor to each led light you have. It take much less power to operate an led then it does stock lights.
Hope this solves your problem!