Question about reaming valve guides
  • ksmegamo
    Posts:5
    Joined:Mon Jan 02, 2006 10:34 am
    Question about reaming valve guides

    by ksmegamo » Thu Feb 01, 2007 3:43 pm

    I bought a new head and I was wondering if the valve guides need to be reamed before assembling the valves? I have the shop manual, and it discusses this, but not necessarily for a new head? If it must be done, where can I buy the tool? None of the major magazines or web sites have one listed in their tools section.

    Thanks
  • matt watt
    Posts:95
    Joined:Sat May 27, 2006 1:19 pm

    by matt watt » Fri Feb 02, 2007 8:09 pm

    Put some oil on the valve stem and see how they fit in the guides. they should move freely with VERY little side to side play. if they are tight take the head and valves to a machine shop for reaming.
    04 CRF250X

Who is online

Users browsing this forum: No registered users and 4 guests