CRF's Only Forums

I just got the twiniar for my bike and was attempting the install when I noticed that the opening for the bolt (in the rubber grommet) is much smaller than on the stock air filter. Is this common? When I put the filter around the cage, the extension tube kind of made the Twinair pop up like a tent. The stock screw does not seem long enough and I cant seem to set the screw to bolt it down in the airbox.

Am I just clueless???? Any suggestions would be greatly appreciated. I did call twinair and they are sending me an additional grommet, but if there is another solution, I would love to hear it.

if I knew how to add pictures to my post I would post them for all to see

Well, as for my last post where I asked "am I clueless", the answer is "yes"!
Please disregard this question....I figured it out!

Did you push the end of the cage into the grommet?

doh......yeah....and a little gentle force = a nice snug fit!

Napalm filter screw...

I'm gonna buy the napalm screw on my next trip to Chaparral. Thanks to both of the "Smiths", Agent and Mister for your help =)

Fits great now.,

As an off topic question......has anyone heard/used/has an opinion of the PowerNow product by Scary Fast?

I was wondering if the power gains make that a worthy purchase at just under $100.00

The powernow seems like a bit of a waste IMO, reminds me of the tornado for vehicles.. Theres some hype of the hotcams stage 1 that cost a bit more but i'm sure you'll see more noticable gains through the bottom-mid range.