[hondapunk53]

How can i change my crf150r into a 150x besides tank pipe handgaurds, and suspention

[Old-Man]

You can't, I don't know of any way to put a e-start on it.

[hondapunk53]

no i still want to race but i want it to be trail tuff

[itsgrady]

Skid-plate, heavy flywheel, O-ring chain, chain and rotor guards, the list goes on.....

[hondapunk53]

why a heavy wheight flywheel there isnt a problem with the hit and i have a o-ring chain

[itsgrady]

It's not just the hit, but it makes the bike more difficult to stall and reduces wheel spin.

[bocephus450x]

pro circuit built one for Dirt Riders 24hr Endurance test that was pretty sweet. search for an old article

[hondapunk53]

ya i remember i saw that and its not procirciut dosnt make good products its just it cost way to much and i have a budget of about 300 so for the stuff i can get from that it wouldnt be worth the money

[bocephus450x]

$300 ?

Skid Plate $80
Rad Guards (if available) $90
Jetting $20
Hand guards if ya want $80

i'd skip the flywheel for now, especially since you still want to race it.

[hondapunk53]

yup got hand gaurds i dont want the full hand gaurds because last time i had them i went over the bars and broke 2 fingers

[itsgrady]

yup got hand gaurds i dont want the full hand gaurds because last time i had them i went over the bars and broke 2 fingers

What detriment could they be? Bail! Guards or no guards, there is enough room for your hands to move freely without getting snagged.....

[hondapunk53]

well that easy for u to say but you wernt the one it happend to i got the acerbis vented gaurds that dont attach to the ends of the bars

[crfsonly]

what 420 o-ring are you running with?

[hondapunk53]

what 420 o-ring are you running with?

RK

[itsgrady]

Well I've run guards with and without the aluminum bracing bar, and I've never endoed. Well if you feel any better, I've crashed pretty bad too from being snagged on my bike.