[longball]

Anyone else have an issue trying to get the BBR skidplate to bolt onto their 230 without vicegrips? I can get the back two clamps on but the front bolt doesn't really line up. If I start with the front bolt I have about 3 inches of gap to bolt the rear clamps. I figured it would match up a little better. Any thoughts?

Thanks,

Matt

[krisrtch]

I had to use a c clamp to bend it up to get the bolt to go in. it was a pain in the butt but it went. Put the back clamps on the c clamped it to the down tube and ran the front bolt. i had the same thought when I first put it on I was like what the #$@@. Hope that can help u get it on.