[West Coast Hornet]

Beginning to reassemble my carb after cleaning and noticed the torque values for some of the parts are as low as 0.2 ft-lbs. my torque wrench doesn't have that sort of scale so I was wondering if anyone has a good recommendation on a torque wrench that would work on these low torque values. Thanks.

[staffy24]

i use a kingcrome micro wrench not sure if you can get in the good old us of a

[crfsonly]

personally on the carb i torque to feel. the carb material is soft like butter so be careful no to over tighten.

ken