by Aussiecrf230 » Tue Aug 30, 2016 2:53 am
Is this something new or always been a problem?
Open up your idle mixture screw slightly. You will be surprised when cruising along even at high speeds how the idle mixture affects things at small throttle openings. If it ends up to rich at idle then a move of clip position may help. Assume you have serviced it recently because an old plug etc can cause problems.
Ray
Australia
CRF230F 2004
C30F Power Up needle
Mains 132
Idle 45
2 turns out
Baffle out, Screens In
It starts,it runs,it gets to where all CRFs can get to without the valve or valve plate dramas