06 steam/overheating after new pump
Posted: Fri Mar 25, 2016 10:10 am
Hey, recently did a little bit of work to my 06. New water pump seals/bearings, new balance shaft seals/bearings, valve adjustment and tore apart the carb and cleaned everything. As soon as I got it back together it started no problems. After about 30 seconds i noticed some steam coming from the exhaust and rad cap. Shut it off, checked everything, looked good, started it back up. This time there was a erractic pinging noise that sounds like its coming from the top end to go along with the steam. No coolant or oil is coming from the weep hole, double checked pilot jet settings. Dont know where to start on this one. Any ideas?