[crossbasse]

Hey

I just can't get of the backwheel.
The bolt won't get lose, can someone help me with this?

Thx

Bastian

[staffy24]

do you have the nut of or is that your prob spary with crc or wd40 make sure you have the right size spanner not a cheep one then place a bar or another ring spanner over the end of your spanner and leaver anti clock wise if the nut is of your axle must be ceased you will need to again spray then place a bar (strong bar) in the little hole and work it to get it moving take your time as this can be a slow process make sure you back your chain of first you will no doubt have to replace your berings

[crossbasse]

hey, i don't know if I understand everything u are trying to answer me. The nut is off, but i can't get the axel troug the backwheel. Is there something i need to do before i try to hammer the axel out?

[mappsterr]

When you rear wheel is off the ground, there is pressure on the rear axle. It helps to relieve some pressure by hold the wheel with one hand while tapping the axle through with a hammer and a long screw driver.