by Aussiecrf230 » Tue Jan 29, 2019 4:53 pm
Would suggest the needle and seat is not sealing. Pull the float bowl and ensure everything is clean and no grit from fuel tank stopping the needle sealing.
Might be the float not closing pressing against the needle but most times it is dirt.
Be careful not to lose any bits when pulling apart.
Ray
Australia
CRF230F 2004
C30F Power Up needle
Mains 132
Idle 45
2 turns out
Baffle out, Screens In
It starts,it runs,it gets to where all CRFs can get to without the valve or valve plate dramas