Page 1 of 1
Freaked out
Posted: Thu Jul 19, 2007 1:13 pm
by dirtbikepro64
Im about to do this clutch replacement and ive come to find out i need some tools, i could understand the Clutch Hub Spanner, and i can take the hit of 9 bucks, but then i see this collar A and holder plate which together cost about 140 dollars. And what is this gear holder that i need, i hear some use a penny. is that a temporary thing aor should i do it right and get a holder. which of this tools is a must?
Posted: Fri Jul 20, 2007 6:33 am
by 124
Buy the motion pro clutch holder tool. It also holds the flywheel so you can undo anything attached to the crankshaft...
http://www.motionpro.com/motorcycle/too ... ding_tool/
Posted: Fri Jul 20, 2007 7:07 am
by gal8x
You can make your own. I used aluminum bar stock, 3/16” x 2’. Drill bolt holes and one for the spanner tool, then use the short case bolts and ½” nylon spacers.
Cram clean rags in the case openings and behind the gears so the penny won’t fall into the inner case.
Re: Freaked out
Posted: Fri Jul 20, 2007 7:33 pm
by CRF230RiPPER
dirtbikepro64 wrote:Im about to do this clutch replacement and ive come to find out i need some tools, i could understand the Clutch Hub Spanner, and i can take the hit of 9 bucks, but then i see this collar A and holder plate which together cost about 140 dollars. And what is this gear holder that i need, i hear some use a penny. is that a temporary thing aor should i do it right and get a holder. which of this tools is a must?
You replacing the whole clutch system?....old clutch gone or are you upgrading?...whats the deal?