150f Clutch Problems
  • Garettluedke
    Posts: 1
    Joined: Sun Dec 09, 2018 8:29 pm

    150f Clutch Problems

    by Garettluedke » Sun Dec 09, 2018 8:53 pm

    First post
    2005 150f
    Was told when bought it needed a clutch.
    Soon taking case off I noticed there was a significant amount of play in the plates. I could tell The way it assembled was not right. The back of the inner hub had rubbbed inside the basket a bit.
    Installed new plates and pads. Installed clutch with schematics. Assembled like any other clutch out there. Obvious difference in visual compared to how it was when I got it. Put back together, kick it in gear and it stalls. Nothing. Rev it and ride it around try to warm everything up. Nothing. Adjust cable. Nothing. At a dead end.
  • Aussiecrf230
    Posts: 1962
    Joined: Fri Jan 06, 2006 11:11 pm

    Re: 150f Clutch Problems

    by Aussiecrf230 » Tue Dec 11, 2018 11:53 am

    Hi welcome to the site.
    Are you saying it stalls now even with the clutch lever all the way in?
    Was there a washer behind the clutch assembly to allow it to free spin when disengaged. Not sure if it is done that way on your model bike.
    Ray
    Australia

    CRF230F 2004
    C30F Power Up needle
    Mains 132
    Idle 45
    2 turns out
    Baffle out, Screens In

    It starts,it runs,it gets to where all CRFs can get to without the valve or valve plate dramas
  • benniejag
    Posts: 3
    Joined: Sat Apr 20, 2019 5:52 am

    150f Clutch Problems

    by benniejag » Thu Apr 25, 2019 1:47 am

    Has anyone else had problems getting the four screws on the clutch off? if so how did you get them off?

Who is online

Users browsing this forum: No registered users and 2 guests